Set the day and night mode parameter of the camera. The backlight parameter supports the following values: BACKLIGHTCONTROL: use Backlight Control DYNAMICRANGECONTROL: use Dynamic Range Control OFF: no optimization This may improve image clarity in high contrast situations, but it should be tested at different times of the day and night to ensure there is no negative effect. Optimizing brightness and contrast levels to compensate for differences between dark and bright objects using either BLC or WDR mode. Presets can be found in the Web UI of the camera. The sensitivity to set, a value between 1 (low sensitivity) and 50 (high sensitivity). Either all time schedule presets can be set at once, or a specific preset can be specified. Set the motion detection sensitivity of the camera. The Reolink integration supports all default camera services and additionally provides the following services: Service reolink_dev.set_sensitivity Be aware that this can be reset during a firmware upgrade. It might be disabled by default and can only be enabled when you have a screen connected to the NVR, not via webb or app clients.
⚠️ After executing one of the above installation methods, restart Home Assistant.